Click here to download a PDF file of the mounting instructions.

Materials needed:

1) Copier paper
2) Tape measure
3) Digital or film camera (optional)
4) Pen or pencil

Rectangular pedals:

1) Remove any rubber covers before taking measurements.
2) Draw a rough sketch on a piece of copier paper.
3) Measure width and height of pedal and note on sketch.

Curved pedals (typically brake and clutch):

1) Hold a piece of paper against the side of the pedal and trace the pedal curvature on the paper.
2) Draw two 3" reference lines, one horizontal (below or above the tracing), and one vertical (to either side of the tracing).

Tapered pedals:

1) Remove any rubber covers before taking measurements.
2) Draw a rough sketch of the pedal on a piece of copier paper.
3) Measure width at top, width at bottom, and height of pedal and note on sketch.

Irregularly shaped pedals:

1) Remove any rubber covers before taking measurements.
2) Draw a rough sketch on a piece of copier paper.
3) Measure length of each side of pedal and note on sketch. Please also note all right angles on sketch.